mips: Correct MIPS interrupt glue logic for icount

When hw interrupt pending bits in CP0_Cause are set, the CPU should
see the hw interrupt line as active. The CPU may or may not take the
interrupt based on internal state (global irq mask etc) but the glue
logic shouldn't care.

This fixes MIPS external hw interrupts in combination with -icount.

Signed-off-by: Edgar E. Iglesias <edgar@axis.com>

2 files changed, 0 insertions, 14 deletions

diff --git a/target-mips/cpu.h b/target-mips/cpu.h
index 81051aa004..157885082a 100644
--- a/target-mips/cpu.h
+++ b/target-mips/cpu.h
@@ -597,9 +597,6 @@ void cpu_mips_store_compare (CPUState *env, uint32_t value);
 void cpu_mips_start_count(CPUState *env);
 void cpu_mips_stop_count(CPUState *env);
 
-/* mips_int.c */
-void cpu_mips_update_irq (CPUState *env);
-
 /* helper.c */
 int cpu_mips_handle_mmu_fault (CPUState *env, target_ulong address, int rw,
                                int mmu_idx, int is_softmmu);
diff --git a/target-mips/op_helper.c b/target-mips/op_helper.c
index 8ae510adc1..c9632248a0 100644
--- a/target-mips/op_helper.c
+++ b/target-mips/op_helper.c
@@ -1313,7 +1313,6 @@ void helper_mtc0_status (target_ulong arg1)
         default: cpu_abort(env, "Invalid MMU mode!\n"); break;
         }
     }
-    cpu_mips_update_irq(env);
 }
 
 void helper_mttc0_status(target_ulong arg1)
@@ -1359,12 +1358,6 @@ void helper_mtc0_cause (target_ulong arg1)
         else
             cpu_mips_start_count(env);
     }
-
-    /* Handle the software interrupt as an hardware one, as they
-       are very similar */
-    if (arg1 & CP0Ca_IP_mask) {
-        cpu_mips_update_irq(env);
-    }
 }
 
 void helper_mtc0_ebase (target_ulong arg1)
@@ -1793,8 +1786,6 @@ target_ulong helper_di (void)
     target_ulong t0 = env->CP0_Status;
 
     env->CP0_Status = t0 & ~(1 << CP0St_IE);
-    cpu_mips_update_irq(env);
-
     return t0;
 }
 
@@ -1803,8 +1794,6 @@ target_ulong helper_ei (void)
     target_ulong t0 = env->CP0_Status;
 
     env->CP0_Status = t0 | (1 << CP0St_IE);
-    cpu_mips_update_irq(env);
-
     return t0;
 }