diff options
Diffstat (limited to 'doc/board/ti/ks2_evm.rst')
| -rw-r--r-- | doc/board/ti/ks2_evm.rst | 25 |
1 files changed, 11 insertions, 14 deletions
diff --git a/doc/board/ti/ks2_evm.rst b/doc/board/ti/ks2_evm.rst index 0a789037a6..16c2e57d09 100644 --- a/doc/board/ti/ks2_evm.rst +++ b/doc/board/ti/ks2_evm.rst @@ -17,17 +17,17 @@ Documentation for this board can be found at: The K2HK board is based on Texas Instruments Keystone2 family of SoCs: K2H, K2K. More details on these SoCs are available at company websites: -K2K: http://www.ti.com/product/tci6638k2k -K2H: http://www.ti.com/product/tci6638k2h +K2K: https://www.ti.com/product/tci6638k2k +K2H: https://www.ti.com/product/tci6638k2h The K2E SoC details are available at - http://www.ti.com/lit/ds/symlink/66ak2e05.pdf + https://www.ti.com/lit/ds/symlink/66ak2e05.pdf The K2L SoC details are available at - http://www.ti.com/lit/ds/symlink/tci6630k2l.pdf + https://www.ti.com/lit/ds/symlink/tci6630k2l.pdf The K2G SoC details are available at - http://www.ti.com/lit/ds/symlink/66ak2g02.pdf + https://www.ti.com/lit/ds/symlink/66ak2g02.pdf Board Configuration ------------------- @@ -122,8 +122,7 @@ Don't forget to add CROSS_COMPILE. To build u-boot.bin, u-boot-spi.gph, MLO: -.. prompt:: bash - :prompts: $ +.. prompt:: bash $ make k2hk_evm_defconfig make @@ -197,8 +196,7 @@ instructions: 4. Free Run the target as described earlier (step 4) to get U-Boot prompt 5. At the U-Boot console type following to setup U-Boot environment variables. -.. prompt:: bash - :prompts: => +.. prompt:: bash => setenv addr_uboot 0x87000000 setenv filesize <size in hex of u-boot-spi.gph rounded to hex 0x10000> @@ -226,8 +224,7 @@ instructions: 4. Free Run the target as described earlier (step 4) to get U-Boot prompt 5. At the U-Boot console type following to setup U-Boot environment variables. -.. prompt:: bash - :prompts: => +.. prompt:: bash => setenv filesize <size in hex of MLO rounded to hex 0x10000> run burn_uboot_nand @@ -249,10 +246,10 @@ Open BMC and regular UART terminals. 1. On the regular UART port start xmodem transfer of the u-boot.bin 2. Using BMC terminal set the ARM-UART bootmode and reboot the EVM -.. prompt:: bash +.. prompt:: bash BMC> - BMC> bootmode #4 - MBC> reboot + bootmode #4 + reboot 3. When xmodem is complete you should see the U-Boot starts on the UART port |