diff options
| -rw-r--r-- | arch/arm/mach-zynqmp/include/mach/hardware.h | 5 | ||||
| -rw-r--r-- | board/xilinx/zynqmp/zynqmp.c | 11 | ||||
| -rw-r--r-- | configs/xilinx_zynqmp_virt_defconfig | 1 | ||||
| -rw-r--r-- | drivers/spi/zynqmp_gqspi.c | 18 |
4 files changed, 33 insertions, 2 deletions
diff --git a/arch/arm/mach-zynqmp/include/mach/hardware.h b/arch/arm/mach-zynqmp/include/mach/hardware.h index 3d3c48e247..a798aa0eb9 100644 --- a/arch/arm/mach-zynqmp/include/mach/hardware.h +++ b/arch/arm/mach-zynqmp/include/mach/hardware.h @@ -19,6 +19,11 @@ #define ZYNQMP_CRL_APB_BOOT_PIN_CTRL_OUT_EN_SHIFT 0 #define ZYNQMP_CRL_APB_BOOT_PIN_CTRL_OUT_VAL_SHIFT 8 +#define ZYNQMP_AMS_PS_SYSMON_BASEADDR 0XFFA50800 +#define ZYNQMP_AMS_PS_SYSMON_ANALOG_BUS ((ZYNQMP_AMS_PS_SYSMON_BASEADDR) \ + + 0x00000114) +#define ZYNQMP_PS_SYSMON_ANALOG_BUS_VAL 0x00003210 + #define PS_MODE0 BIT(0) #define PS_MODE1 BIT(1) #define PS_MODE2 BIT(2) diff --git a/board/xilinx/zynqmp/zynqmp.c b/board/xilinx/zynqmp/zynqmp.c index d05f0b2e12..ee4d0c85e6 100644 --- a/board/xilinx/zynqmp/zynqmp.c +++ b/board/xilinx/zynqmp/zynqmp.c @@ -287,6 +287,17 @@ int board_early_init_f(void) if (ret) return ret; + /* + * PS_SYSMON_ANALOG_BUS register determines mapping between SysMon + * supply sense channel to SysMon supply registers inside the IP. + * This register must be programmed to complete SysMon IP + * configuration. The default register configuration after + * power-up is incorrect. Hence, fix this by writing the + * correct value - 0x3210. + */ + writel(ZYNQMP_PS_SYSMON_ANALOG_BUS_VAL, + ZYNQMP_AMS_PS_SYSMON_ANALOG_BUS); + /* Delay is required for clocks to be propagated */ udelay(1000000); #endif diff --git a/configs/xilinx_zynqmp_virt_defconfig b/configs/xilinx_zynqmp_virt_defconfig index e939b04ef6..6adbe987cb 100644 --- a/configs/xilinx_zynqmp_virt_defconfig +++ b/configs/xilinx_zynqmp_virt_defconfig @@ -187,6 +187,5 @@ CONFIG_OF_LIBFDT_OVERLAY=y CONFIG_EFI_SET_TIME=y CONFIG_EFI_RUNTIME_UPDATE_CAPSULE=y CONFIG_EFI_CAPSULE_ON_DISK=y -CONFIG_EFI_CAPSULE_ON_DISK_EARLY=y CONFIG_EFI_CAPSULE_FIRMWARE_FIT=y CONFIG_EFI_CAPSULE_FIRMWARE_RAW=y diff --git a/drivers/spi/zynqmp_gqspi.c b/drivers/spi/zynqmp_gqspi.c index 17780066ae..fc81b07343 100644 --- a/drivers/spi/zynqmp_gqspi.c +++ b/drivers/spi/zynqmp_gqspi.c @@ -39,6 +39,7 @@ #define GQSPI_IXR_TXFULL_MASK 0x00000008 /* QSPI TX FIFO is full */ #define GQSPI_IXR_RXNEMTY_MASK 0x00000010 /* QSPI RX FIFO Not Empty */ #define GQSPI_IXR_GFEMTY_MASK 0x00000080 /* QSPI Generic FIFO Empty */ +#define GQSPI_IXR_GFNFULL_MASK 0x00000200 /* QSPI GENFIFO not full */ #define GQSPI_IXR_ALL_MASK (GQSPI_IXR_TXNFULL_MASK | \ GQSPI_IXR_RXNEMTY_MASK) @@ -238,9 +239,21 @@ static void zynqmp_qspi_fill_gen_fifo(struct zynqmp_qspi_priv *priv, u32 gqspi_fifo_reg) { struct zynqmp_qspi_regs *regs = priv->regs; + u32 config_reg, ier; int ret = 0; - ret = wait_for_bit_le32(®s->isr, GQSPI_IXR_GFEMTY_MASK, 1, + config_reg = readl(®s->confr); + /* Manual start if needed */ + config_reg |= GQSPI_STRT_GEN_FIFO; + writel(config_reg, ®s->confr); + + /* Enable interrupts */ + ier = readl(®s->ier); + ier |= GQSPI_IXR_GFNFULL_MASK; + writel(ier, ®s->ier); + + /* Wait until the fifo is not full to write the new command */ + ret = wait_for_bit_le32(®s->isr, GQSPI_IXR_GFNFULL_MASK, 1, GQSPI_TIMEOUT, 1); if (ret) printf("%s Timeout\n", __func__); @@ -263,6 +276,9 @@ static void zynqmp_qspi_chipselect(struct zynqmp_qspi_priv *priv, int is_on) debug("GFIFO_CMD_CS: 0x%x\n", gqspi_fifo_reg); + /* Dummy generic FIFO entry */ + zynqmp_qspi_fill_gen_fifo(priv, 0); + zynqmp_qspi_fill_gen_fifo(priv, gqspi_fifo_reg); } |