diff options
| author | Patrick Delaunay <patrick.delaunay@st.com> | 2020-01-13 11:35:07 +0100 |
|---|---|---|
| committer | Tom Rini <trini@konsulko.com> | 2020-04-16 23:06:54 -0400 |
| commit | 477ca57b9a53120a14bdca356612fce15211345d (patch) | |
| tree | 8ede882b3395eda2e70c38d8b4ad1b1772e6bc7b /include/asm-generic | |
| parent | 695e5fd5469ab052126c4cb30c4d26e6058de067 (diff) | |
| download | u-boot-477ca57b9a53120a14bdca356612fce15211345d.tar.gz u-boot-477ca57b9a53120a14bdca356612fce15211345d.tar.bz2 u-boot-477ca57b9a53120a14bdca356612fce15211345d.zip | |
gpio: add support of new GPIO direction flag
This commit manages the new dir flags that can be used in gpio
specifiers to indicate the pull-up or pull-down resistor
configuration for output gpio (GPIO_PULL_UP, GPIO_PULL_DOWN)
or the Open Drain/Open Source configuration for input gpio
(GPIO_OPEN_DRAIN, GPIO_OPEN_SOURCE).
These flags are already supported in Linux kernel in gpio lib.
This patch only parse and save the direction flags in GPIO
descriptor (desc->flags), it prepares the introduction of new ops
to manage them.
The GPIO uclass supports new GPIO flags from device-tree
(GPIO_XXX define in include/dt-bindings/gpio/gpio.h)
and translate them in the dir flags (GPIOD_XXX):
- GPIO_PULL_UP => GPIOD_PULL_UP
- GPIO_PULL_DOWN => GPIOD_PULL_DOWN
- GPIO_OPEN_DRAIN => GPIOD_OPEN_DRAIN
- GPIO_OPEN_SOURCE => GPIOD_OPEN_SOURCE
This patch also adds protection in the check_dir_flags function for
new invalid configuration of the dir flags.
Signed-off-by: Patrick Delaunay <patrick.delaunay@st.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
Diffstat (limited to 'include/asm-generic')
| -rw-r--r-- | include/asm-generic/gpio.h | 6 |
1 files changed, 5 insertions, 1 deletions
diff --git a/include/asm-generic/gpio.h b/include/asm-generic/gpio.h index 1329d02f87..42c9ab29ca 100644 --- a/include/asm-generic/gpio.h +++ b/include/asm-generic/gpio.h @@ -119,8 +119,12 @@ struct gpio_desc { unsigned long flags; #define GPIOD_IS_OUT BIT(1) /* GPIO is an output */ #define GPIOD_IS_IN BIT(2) /* GPIO is an input */ -#define GPIOD_ACTIVE_LOW BIT(3) /* value has active low */ +#define GPIOD_ACTIVE_LOW BIT(3) /* GPIO is active when value is low */ #define GPIOD_IS_OUT_ACTIVE BIT(4) /* set output active */ +#define GPIOD_OPEN_DRAIN BIT(5) /* GPIO is open drain type */ +#define GPIOD_OPEN_SOURCE BIT(6) /* GPIO is open source type */ +#define GPIOD_PULL_UP BIT(7) /* GPIO has pull-up enabled */ +#define GPIOD_PULL_DOWN BIT(8) /* GPIO has pull-down enabled */ uint offset; /* GPIO offset within the device */ /* |