diff options
| author | pekon gupta <pekon@ti.com> | 2014-07-18 17:59:42 +0530 |
|---|---|---|
| committer | Tom Rini <trini@ti.com> | 2014-07-25 16:26:12 -0400 |
| commit | 434f2cfcad9f70231ad5a096325ba72ef0d2a2cc (patch) | |
| tree | 82a3f5dcec21d63f482868eab003308e5e4ecc3c /doc | |
| parent | 222a3113b46c4a16de3f51747201ca6565c8ee6a (diff) | |
| download | u-boot-434f2cfcad9f70231ad5a096325ba72ef0d2a2cc.tar.gz u-boot-434f2cfcad9f70231ad5a096325ba72ef0d2a2cc.tar.bz2 u-boot-434f2cfcad9f70231ad5a096325ba72ef0d2a2cc.zip | |
ARM: omap: move board specific NAND configs out from ti_armv7_common.h
This patch moves some board specific NAND configs:
- FROM: generic config file 'ti_armv7_common.h'
- TO: individual board config files using these configs.
So that each board can independently set the value as per its design.
Following configs are affected in this patch:
CONFIG_SYS_NAND_U_BOOT_OFFS: <refer doc/README.nand>
CONFIG_CMD_SPL_NAND_OFS: <refer doc/README.falcon>
CONFIG_SYS_NAND_SPL_KERNEL_OFFS: <refer doc/README.falcon>
CONFIG_CMD_SPL_WRITE_SIZE: <refer doc/README.falcon>
This patch also updates documentation for few of above NAND configs.
Signed-off-by: Pekon Gupta <pekon@ti.com>
Diffstat (limited to 'doc')
| -rw-r--r-- | doc/README.nand | 12 |
1 files changed, 12 insertions, 0 deletions
diff --git a/doc/README.nand b/doc/README.nand index 70cf768d23..e29188f1ec 100644 --- a/doc/README.nand +++ b/doc/README.nand @@ -89,6 +89,10 @@ Commands: Configuration Options: + CONFIG_SYS_NAND_U_BOOT_OFFS + NAND Offset from where SPL will read u-boot image. This is the starting + address of u-boot MTD partition in NAND. + CONFIG_CMD_NAND Enables NAND support and commmands. @@ -226,6 +230,14 @@ Platform specific options detection. However ECC calculation on such plaforms would still be done by GPMC controller. + CONFIG_SPL_NAND_AM33XX_BCH + Enables SPL-NAND driver (am335x_spl_bch.c) which supports ELM based + hardware ECC correction. This is useful for platforms which have ELM + hardware engine and use NAND boot mode. + Some legacy platforms like OMAP3xx do not have in-built ELM h/w engine, + so those platforms should use CONFIG_SPL_NAND_SIMPLE for enabling + SPL-NAND driver with software ECC correction support. + CONFIG_NAND_OMAP_ECCSCHEME On OMAP platforms, this CONFIG specifies NAND ECC scheme. It can take following values: |