diff options
Diffstat (limited to 'drivers/mmc/host')
| -rw-r--r-- | drivers/mmc/host/mmci.c | 19 | ||||
| -rw-r--r-- | drivers/mmc/host/mmci.h | 6 | ||||
| -rw-r--r-- | drivers/mmc/host/pxamci.c | 2 |
3 files changed, 21 insertions, 6 deletions
diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c index 84c103a7ee1..ff115d92088 100644 --- a/drivers/mmc/host/mmci.c +++ b/drivers/mmc/host/mmci.c @@ -55,14 +55,16 @@ static void mmci_set_clkreg(struct mmci_host *host, unsigned int desired) host->cclk = host->mclk / (2 * (clk + 1)); } if (host->hw_designer == AMBA_VENDOR_ST) - clk |= MCI_FCEN; /* Bug fix in ST IP block */ + clk |= MCI_ST_FCEN; /* Bug fix in ST IP block */ clk |= MCI_CLK_ENABLE; /* This hasn't proven to be worthwhile */ /* clk |= MCI_CLK_PWRSAVE; */ } if (host->mmc->ios.bus_width == MMC_BUS_WIDTH_4) - clk |= MCI_WIDE_BUS; + clk |= MCI_4BIT_BUS; + if (host->mmc->ios.bus_width == MMC_BUS_WIDTH_8) + clk |= MCI_ST_8BIT_BUS; writel(clk, host->base + MMCICLOCK); } @@ -629,7 +631,18 @@ static int __devinit mmci_probe(struct amba_device *dev, struct amba_id *id) mmc->ops = &mmci_ops; mmc->f_min = (host->mclk + 511) / 512; - mmc->f_max = min(host->mclk, fmax); + /* + * If the platform data supplies a maximum operating + * frequency, this takes precedence. Else, we fall back + * to using the module parameter, which has a (low) + * default value in case it is not specified. Either + * value must not exceed the clock rate into the block, + * of course. + */ + if (plat->f_max) + mmc->f_max = min(host->mclk, plat->f_max); + else + mmc->f_max = min(host->mclk, fmax); dev_dbg(mmc_dev(mmc), "clocking block at %u Hz\n", mmc->f_max); #ifdef CONFIG_REGULATOR diff --git a/drivers/mmc/host/mmci.h b/drivers/mmc/host/mmci.h index 1ceb9a90f59..d77062e5e3a 100644 --- a/drivers/mmc/host/mmci.h +++ b/drivers/mmc/host/mmci.h @@ -25,9 +25,11 @@ #define MCI_CLK_ENABLE (1 << 8) #define MCI_CLK_PWRSAVE (1 << 9) #define MCI_CLK_BYPASS (1 << 10) -#define MCI_WIDE_BUS (1 << 11) +#define MCI_4BIT_BUS (1 << 11) +/* 8bit wide buses supported in ST Micro versions */ +#define MCI_ST_8BIT_BUS (1 << 12) /* HW flow control on the ST Micro version */ -#define MCI_FCEN (1 << 13) +#define MCI_ST_FCEN (1 << 13) #define MMCIARGUMENT 0x008 #define MMCICOMMAND 0x00c diff --git a/drivers/mmc/host/pxamci.c b/drivers/mmc/host/pxamci.c index 0ed48959b59..e4f00e70a74 100644 --- a/drivers/mmc/host/pxamci.c +++ b/drivers/mmc/host/pxamci.c @@ -544,7 +544,7 @@ static irqreturn_t pxamci_detect_irq(int irq, void *devid) { struct pxamci_host *host = mmc_priv(devid); - mmc_detect_change(devid, host->pdata->detect_delay); + mmc_detect_change(devid, msecs_to_jiffies(host->pdata->detect_delay_ms)); return IRQ_HANDLED; } |