/* SPDX-License-Identifier: GPL-2.0+ */ /* * Copyright 2020-2021 Toradex */ #ifndef __VERDIN_IMX8MM_H #define __VERDIN_IMX8MM_H #include #include #define CONFIG_SYS_MONITOR_LEN SZ_512K #define CONFIG_SYS_UBOOT_BASE \ (QSPI0_AMBA_BASE + CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR * 512) #ifdef CONFIG_SPL_BUILD /* malloc f used before GD_FLG_FULL_MALLOC_INIT set */ #define CONFIG_MALLOC_F_ADDR 0x930000 /* For RAW image gives a error info not panic */ #endif #define MEM_LAYOUT_ENV_SETTINGS \ "fdt_addr_r=0x50200000\0" \ "kernel_addr_r=" __stringify(CONFIG_SYS_LOAD_ADDR) "\0" \ "kernel_comp_addr_r=0x40200000\0" \ "kernel_comp_size=0x08000000\0" \ "ramdisk_addr_r=0x50300000\0" \ "scriptaddr=0x50280000\0" /* Enable Distro Boot */ #define BOOT_TARGET_DEVICES(func) \ func(MMC, mmc, 1) \ func(MMC, mmc, 0) \ func(DHCP, dhcp, na) #include /* Initial environment variables */ #define CONFIG_EXTRA_ENV_SETTINGS \ BOOTENV \ MEM_LAYOUT_ENV_SETTINGS \ "bootcmd_mfg=fastboot 0\0" \ "boot_file=Image\0" \ "boot_script_dhcp=boot.scr\0" \ "console=ttymxc0\0" \ "fdt_addr=0x43000000\0" \ "fdt_board=dev\0" \ "initrd_addr=0x43800000\0" \ "initrd_high=0xffffffffffffffff\0" \ "setup=setenv setupargs console=tty1 console=${console},${baudrate} " \ "consoleblank=0 earlycon\0" \ "update_uboot=askenv confirm Did you load flash.bin (y/N)?; " \ "if test \"$confirm\" = \"y\"; then " \ "setexpr blkcnt ${filesize} + 0x1ff && setexpr blkcnt " \ "${blkcnt} / 0x200; mmc dev 0 1; mmc write ${loadaddr} 0x2 " \ "${blkcnt}; fi\0" #define CONFIG_SYS_INIT_RAM_ADDR 0x40000000 #define CONFIG_SYS_INIT_RAM_SIZE SZ_2M #if defined(CONFIG_ENV_IS_IN_MMC) /* Environment in eMMC, before config block at the end of 1st "boot sector" */ #endif #define CONFIG_SYS_SDRAM_BASE 0x40000000 /* SDRAM configuration */ #define PHYS_SDRAM 0x40000000 #define PHYS_SDRAM_SIZE SZ_2G /* 2GB DDR */ /* USB Configs */ #define CONFIG_MXC_USB_PORTSC (PORT_PTS_UTMI | PORT_PTS_PTW) #endif /* __VERDIN_IMX8MM_H */