From 3d22bae57f1e5f0f0d3f69216e8aae27e8a797c4 Mon Sep 17 00:00:00 2001 From: Tuomas Tynkkynen Date: Fri, 5 Jan 2018 02:45:17 +0200 Subject: fs: Migrate ext4 to Kconfig Migrate the following symbols to Kconfig: CONFIG_FS_EXT4 CONFIG_EXT4_WRITE The definitions in config_fallbacks.h can now be expressed in Kconfig. Signed-off-by: Tuomas Tynkkynen --- doc/README.ext4 | 22 +++++++++++----------- 1 file changed, 11 insertions(+), 11 deletions(-) (limited to 'doc') diff --git a/doc/README.ext4 b/doc/README.ext4 index 2b0eab5dde..8ecd21eee3 100644 --- a/doc/README.ext4 +++ b/doc/README.ext4 @@ -2,10 +2,10 @@ U-Boot supports access of both ext2 and ext4 filesystems, either in read-only mode or in read-write mode. First, to enable support for both ext4 (and, automatically, ext2 as well), -but without selecting the corresponding commands, use one of: +but without selecting the corresponding commands, enable one of the following: - #define CONFIG_FS_EXT4 (for read-only) - #define CONFIG_EXT4_WRITE (for read-write) + CONFIG_FS_EXT4 (for read-only) + CONFIG_EXT4_WRITE (for read-write) Next, to select the ext2-related commands: @@ -20,22 +20,22 @@ or ext4-related commands: use one or both of: - #define CONFIG_CMD_EXT2 - #define CONFIG_CMD_EXT4 + CONFIG_CMD_EXT2 + CONFIG_CMD_EXT4 -Selecting either of the above automatically defines CONFIG_FS_EXT4 if it -wasn't defined already. +Selecting either of the above automatically selects CONFIG_FS_EXT4 if it +wasn't enabled already. -In addition, to get the write access command "ext4write", use: +In addition, to get the write access command "ext4write", enable: - #define CONFIG_CMD_EXT4_WRITE + CONFIG_CMD_EXT4_WRITE -which automatically defines CONFIG_EXT4_WRITE if it wasn't defined +which automatically selects CONFIG_EXT4_WRITE if it wasn't defined already. Also relevant are the generic filesystem commands, selected by: - #define CONFIG_CMD_FS_GENERIC + CONFIG_CMD_FS_GENERIC This does not automatically enable EXT4 support for you, you still need to do that yourself. -- cgit v1.2.3