diff options
Diffstat (limited to 'include/mtd/mtd-abi.h')
| -rw-r--r-- | include/mtd/mtd-abi.h | 183 |
1 files changed, 131 insertions, 52 deletions
diff --git a/include/mtd/mtd-abi.h b/include/mtd/mtd-abi.h index ac3c298760..b9f4bcb154 100644 --- a/include/mtd/mtd-abi.h +++ b/include/mtd/mtd-abi.h @@ -1,30 +1,44 @@ /* - * $Id: mtd-abi.h,v 1.13 2005/11/07 11:14:56 gleixner Exp $ + * Copyright © 1999-2010 David Woodhouse <dwmw2@infradead.org> et al. + * + * SPDX-License-Identifier: GPL-2.0+ * - * Portions of MTD ABI definition which are shared by kernel and user space */ #ifndef __MTD_ABI_H__ #define __MTD_ABI_H__ -#if 1 +#define __UBOOT__ +#ifdef __UBOOT__ #include <linux/compat.h> #endif #include <linux/compiler.h> struct erase_info_user { - uint32_t start; - uint32_t length; + __u32 start; + __u32 length; +}; + +struct erase_info_user64 { + __u64 start; + __u64 length; }; struct mtd_oob_buf { - uint32_t start; - uint32_t length; + __u32 start; + __u32 length; unsigned char __user *ptr; }; -/* +struct mtd_oob_buf64 { + __u64 start; + __u32 pad; + __u32 length; + __u64 usr_ptr; +}; + +/** * MTD operation modes * * @MTD_OPS_PLACE_OOB: OOB data are placed at the given offset (default) @@ -43,18 +57,45 @@ enum { MTD_OPS_RAW = 2, }; +/** + * struct mtd_write_req - data structure for requesting a write operation + * + * @start: start address + * @len: length of data buffer + * @ooblen: length of OOB buffer + * @usr_data: user-provided data buffer + * @usr_oob: user-provided OOB buffer + * @mode: MTD mode (see "MTD operation modes") + * @padding: reserved, must be set to 0 + * + * This structure supports ioctl(MEMWRITE) operations, allowing data and/or OOB + * writes in various modes. To write to OOB-only, set @usr_data == NULL, and to + * write data-only, set @usr_oob == NULL. However, setting both @usr_data and + * @usr_oob to NULL is not allowed. + */ +struct mtd_write_req { + __u64 start; + __u64 len; + __u64 ooblen; + __u64 usr_data; + __u64 usr_oob; + __u8 mode; + __u8 padding[7]; +}; + #define MTD_ABSENT 0 #define MTD_RAM 1 #define MTD_ROM 2 #define MTD_NORFLASH 3 -#define MTD_NANDFLASH 4 +#define MTD_NANDFLASH 4 /* SLC NAND */ #define MTD_DATAFLASH 6 #define MTD_UBIVOLUME 7 +#define MTD_MLCNANDFLASH 8 /* MLC NAND (including TLC) */ #define MTD_WRITEABLE 0x400 /* Device is writeable */ #define MTD_BIT_WRITEABLE 0x800 /* Single bits can be flipped */ #define MTD_NO_ERASE 0x1000 /* No erase necessary */ -#define MTD_STUPID_LOCK 0x2000 /* Always locked after reset */ +#define MTD_POWERUP_LOCK 0x2000 /* Always locked after reset */ /* Some common devices / combinations of capabilities */ #define MTD_CAP_ROM 0 @@ -62,12 +103,12 @@ enum { #define MTD_CAP_NORFLASH (MTD_WRITEABLE | MTD_BIT_WRITEABLE) #define MTD_CAP_NANDFLASH (MTD_WRITEABLE) -/* ECC byte placement */ -#define MTD_NANDECC_OFF 0 /* Switch off ECC (Not recommended) */ -#define MTD_NANDECC_PLACE 1 /* Use the given placement in the structure (YAFFS1 legacy mode) */ -#define MTD_NANDECC_AUTOPLACE 2 /* Use the default placement scheme */ -#define MTD_NANDECC_PLACEONLY 3 /* Use the given placement in the structure (Do not store ecc result on read) */ -#define MTD_NANDECC_AUTOPL_USR 4 /* Use the given autoplacement scheme rather than using the default */ +/* Obsolete ECC byte placement modes (used with obsolete MEMGETOOBSEL) */ +#define MTD_NANDECC_OFF 0 // Switch off ECC (Not recommended) +#define MTD_NANDECC_PLACE 1 // Use the given placement in the structure (YAFFS1 legacy mode) +#define MTD_NANDECC_AUTOPLACE 2 // Use the default placement scheme +#define MTD_NANDECC_PLACEONLY 3 // Use the given placement in the structure (Do not store ecc result on read) +#define MTD_NANDECC_AUTOPL_USR 4 // Use the given autoplacement scheme rather than using the default /* OTP mode selection */ #define MTD_OTP_OFF 0 @@ -75,32 +116,35 @@ enum { #define MTD_OTP_USER 2 struct mtd_info_user { - uint8_t type; - uint32_t flags; - uint32_t size; /* Total size of the MTD */ - uint32_t erasesize; - uint32_t writesize; - uint32_t oobsize; /* Amount of OOB data per block (e.g. 16) */ - /* The below two fields are obsolete and broken, do not use them - * (TODO: remove at some point) */ - uint32_t ecctype; - uint32_t eccsize; + __u8 type; + __u32 flags; + __u32 size; /* Total size of the MTD */ + __u32 erasesize; + __u32 writesize; + __u32 oobsize; /* Amount of OOB data per block (e.g. 16) */ + __u64 padding; /* Old obsolete field; do not use */ }; struct region_info_user { - uint32_t offset; /* At which this region starts, - * from the beginning of the MTD */ - uint32_t erasesize; /* For this region */ - uint32_t numblocks; /* Number of blocks in this region */ - uint32_t regionindex; + __u32 offset; /* At which this region starts, + * from the beginning of the MTD */ + __u32 erasesize; /* For this region */ + __u32 numblocks; /* Number of blocks in this region */ + __u32 regionindex; }; struct otp_info { - uint32_t start; - uint32_t length; - uint32_t locked; + __u32 start; + __u32 length; + __u32 locked; }; +/* + * Note, the following ioctl existed in the past and was removed: + * #define MEMSETOOBSEL _IOW('M', 9, struct nand_oobinfo) + * Try to avoid adding a new ioctl with the same ioctl number. + */ + /* Get basic MTD characteristics info (better to use sysfs) */ #define MEMGETINFO _IOR('M', 1, struct mtd_info_user) /* Erase segment of MTD */ @@ -118,12 +162,11 @@ struct otp_info { /* Get information about the erase region for a specific index */ #define MEMGETREGIONINFO _IOWR('M', 8, struct region_info_user) /* Get info about OOB modes (e.g., RAW, PLACE, AUTO) - legacy interface */ -#define MEMSETOOBSEL _IOW('M', 9, struct nand_oobinfo) #define MEMGETOOBSEL _IOR('M', 10, struct nand_oobinfo) /* Check if an eraseblock is bad */ -#define MEMGETBADBLOCK _IOW('M', 11, loff_t) +#define MEMGETBADBLOCK _IOW('M', 11, __kernel_loff_t) /* Mark an eraseblock as bad */ -#define MEMSETBADBLOCK _IOW('M', 12, loff_t) +#define MEMSETBADBLOCK _IOW('M', 12, __kernel_loff_t) /* Set OTP (One-Time Programmable) mode (factory vs. user) */ #define OTPSELECT _IOR('M', 13, int) /* Get number of OTP (One-Time Programmable) regions */ @@ -133,26 +176,57 @@ struct otp_info { /* Lock a given range of user data (must be in mode %MTD_FILE_MODE_OTP_USER) */ #define OTPLOCK _IOR('M', 16, struct otp_info) /* Get ECC layout (deprecated) */ -#define ECCGETLAYOUT _IOR('M', 17, struct nand_ecclayout) +#define ECCGETLAYOUT _IOR('M', 17, struct nand_ecclayout_user) /* Get statistics about corrected/uncorrected errors */ #define ECCGETSTATS _IOR('M', 18, struct mtd_ecc_stats) /* Set MTD mode on a per-file-descriptor basis (see "MTD file modes") */ #define MTDFILEMODE _IO('M', 19) +/* Erase segment of MTD (supports 64-bit address) */ +#define MEMERASE64 _IOW('M', 20, struct erase_info_user64) +/* Write data to OOB (64-bit version) */ +#define MEMWRITEOOB64 _IOWR('M', 21, struct mtd_oob_buf64) +/* Read data from OOB (64-bit version) */ +#define MEMREADOOB64 _IOWR('M', 22, struct mtd_oob_buf64) +/* Check if chip is locked (for MTD that supports it) */ +#define MEMISLOCKED _IOR('M', 23, struct erase_info_user) +/* + * Most generic write interface; can write in-band and/or out-of-band in various + * modes (see "struct mtd_write_req"). This ioctl is not supported for flashes + * without OOB, e.g., NOR flash. + */ +#define MEMWRITE _IOWR('M', 24, struct mtd_write_req) /* * Obsolete legacy interface. Keep it in order not to break userspace * interfaces */ struct nand_oobinfo { - uint32_t useecc; - uint32_t eccbytes; - uint32_t oobfree[8][2]; - uint32_t eccpos[48]; + __u32 useecc; + __u32 eccbytes; + __u32 oobfree[8][2]; + __u32 eccpos[32]; }; struct nand_oobfree { - uint32_t offset; - uint32_t length; + __u32 offset; + __u32 length; +}; + +#define MTD_MAX_OOBFREE_ENTRIES 8 +#define MTD_MAX_ECCPOS_ENTRIES 64 +/* + * OBSOLETE: ECC layout control structure. Exported to user-space via ioctl + * ECCGETLAYOUT for backwards compatbility and should not be mistaken as a + * complete set of ECC information. The ioctl truncates the larger internal + * structure to retain binary compatibility with the static declaration of the + * ioctl. Note that the "MTD_MAX_..._ENTRIES" macros represent the max size of + * the user struct, not the MAX size of the internal struct nand_ecclayout. + */ +struct nand_ecclayout_user { + __u32 eccbytes; + __u32 eccpos[MTD_MAX_ECCPOS_ENTRIES]; + __u32 oobavail; + struct nand_oobfree oobfree[MTD_MAX_OOBFREE_ENTRIES]; }; /** @@ -164,10 +238,10 @@ struct nand_oobfree { * @bbtblocks: number of blocks reserved for bad block tables */ struct mtd_ecc_stats { - uint32_t corrected; - uint32_t failed; - uint32_t badblocks; - uint32_t bbtblocks; + __u32 corrected; + __u32 failed; + __u32 badblocks; + __u32 bbtblocks; }; /* @@ -188,10 +262,15 @@ struct mtd_ecc_stats { * used out of necessity (e.g., `write()', ioctl(MEMWRITEOOB64)). */ enum mtd_file_modes { - MTD_MODE_NORMAL = MTD_OTP_OFF, - MTD_MODE_OTP_FACTORY = MTD_OTP_FACTORY, - MTD_MODE_OTP_USER = MTD_OTP_USER, - MTD_MODE_RAW, + MTD_FILE_MODE_NORMAL = MTD_OTP_OFF, + MTD_FILE_MODE_OTP_FACTORY = MTD_OTP_FACTORY, + MTD_FILE_MODE_OTP_USER = MTD_OTP_USER, + MTD_FILE_MODE_RAW, }; +static inline int mtd_type_is_nand_user(const struct mtd_info_user *mtd) +{ + return mtd->type == MTD_NANDFLASH || mtd->type == MTD_MLCNANDFLASH; +} + #endif /* __MTD_ABI_H__ */ |