* Make Ethernet autonegotiation on INCA-IP work for all clock rates;

  allow selection of clock frequency as "make" target

* Implement memory autosizing code for IceCube boards

* Configure network port on INCA-IP for autonegotiation

* Fix overflow problem in network timeout code

* Patch by Richard Woodruff, 8 Aug 2003:
  Allow crc32 to be used at address 0x000 (crc32_no_comp, too).

1 files changed, 14 insertions, 0 deletions

diff --git a/doc/README.INCA-IP b/doc/README.INCA-IP
index 517eec0401..7421b6ed24 100644
--- a/doc/README.INCA-IP
+++ b/doc/README.INCA-IP
@@ -41,4 +41,18 @@ to install a U-Boot image into flash.
 	go 0xb0000000
 
 
+
+Ethernet autonegotiation needs some time to complete. Instead of
+delaying the boot process in all cases, we just start the
+autonegotiation process when U-Boot comes up and that is all. Most
+likely, it will complete by the time the network transfer is
+attempted for the first time. In the worst case, if a transfer is
+attempted before the autonegotiation is complete, just a single
+packet would be lost resulting in a single timeout error, and then
+the transfer would proceed normally. So the time that we would have
+lost unconditionally waiting for the autonegotiation to complete, we
+have to wait only if the file transfer is started immediately after
+reset. We've verified that this works for all the clock
+configurations.
+
 (C) 2003 Wolfgang Denk