x86: irq: Enable SCI on IRQ9

By default SCI is disabled after power on. ACTL is the register to
enable SCI and route it to PIC/APIC. To support both ACPI in PIC
mode and APIC mode, configure SCI to use IRQ9.

Signed-off-by: Bin Meng <bmeng.cn@gmail.com>
Reviewed-by: Stefan Roese <sr@denx.de>
Tested-by: Stefan Roese <sr@denx.de>

1 files changed, 5 insertions, 0 deletions

diff --git a/doc/device-tree-bindings/misc/intel,irq-router.txt b/doc/device-tree-bindings/misc/intel,irq-router.txt
index e4d8ead2ee..04ad34654c 100644
--- a/doc/device-tree-bindings/misc/intel,irq-router.txt
+++ b/doc/device-tree-bindings/misc/intel,irq-router.txt
@@ -14,6 +14,11 @@ Required properties :
       "ibase": IRQ routing is in the memory-mapped IBASE register block
 - intel,ibase-offset : IBASE register offset in the interrupt router's PCI
     configuration space, required only if intel,pirq-config = "ibase".
+- intel,actl-8bit : If ACTL (ACPI control) register width is 8-bit, this must
+    be specified. The 8-bit ACTL register is seen on ICH series chipset, like
+    ICH9/Panther Point/etc. On Atom chipset it is a 32-bit register.
+- intel,actl-addr : ACTL (ACPI control) register offset. ACTL can be either
+    in the interrupt router's PCI configuration space, or IBASE.
 - intel,pirq-link : Specifies the PIRQ link information with two cells. The
     first cell is the register offset that controls the first PIRQ link routing.
     The second cell is the total number of PIRQ links the router supports.