mac80211: remove ARP filter enable/disable logic

Depending on the driver, having ARP filtering for
some addresses may be possible. Remove the logic
that tracks whether ARP filter is enabled or not
and give the driver the total number of addresses
instead of the length of the list so it can make
its own decision.

Reviewed-by: Luciano Coelho <coelho@ti.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

1 files changed, 4 insertions, 7 deletions

diff --git a/include/net/mac80211.h b/include/net/mac80211.h
index e0825a9dbfea..679ad4bb222b 100644
--- a/include/net/mac80211.h
+++ b/include/net/mac80211.h
@@ -297,11 +297,9 @@ enum ieee80211_rssi_event {
  *	may filter ARP queries targeted for other addresses than listed here.
  *	The driver must allow ARP queries targeted for all address listed here
  *	to pass through. An empty list implies no ARP queries need to pass.
- * @arp_addr_cnt: Number of addresses currently on the list.
- * @arp_filter_enabled: Enable ARP filtering - if enabled, the hardware may
- *	filter ARP queries based on the @arp_addr_list, if disabled, the
- *	hardware must not perform any ARP filtering. Note, that the filter will
- *	be enabled also in promiscuous mode.
+ * @arp_addr_cnt: Number of addresses currently on the list. Note that this
+ *	may be larger than %IEEE80211_BSS_ARP_ADDR_LIST_LEN (the arp_addr_list
+ *	array size), it's up to the driver what to do in that case.
  * @qos: This is a QoS-enabled BSS.
  * @idle: This interface is idle. There's also a global idle flag in the
  *	hardware config which may be more appropriate depending on what
@@ -338,8 +336,7 @@ struct ieee80211_bss_conf {
 	u32 cqm_rssi_hyst;
 	struct cfg80211_chan_def chandef;
 	__be32 arp_addr_list[IEEE80211_BSS_ARP_ADDR_LIST_LEN];
-	u8 arp_addr_cnt;
-	bool arp_filter_enabled;
+	int arp_addr_cnt;
 	bool qos;
 	bool idle;
 	bool ps;