Davicom DM9102(A)/DM9132/DM9801 fast ethernet driver for Linux. This program is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation; either version 2 of the License, or (at your option) any later version. This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details. This driver provides kernel support for Davicom DM9102(A)/DM9132/DM9801 ethernet cards ( CNET 10/100 ethernet cards uses Davicom chipset too, so this driver supports CNET cards too ).If you didn't compile this driver as a module, it will automatically load itself on boot and print a line similar to : dmfe: Davicom DM9xxx net driver, version 1.36.4 (2002-01-17) If you compiled this driver as a module, you have to load it on boot.You can load it with command : insmod dmfe This way it will autodetect the device mode.This is the suggested way to load the module.Or you can pass a mode= setting to module while loading, like : insmod dmfe mode=0 # Force 10M Half Duplex insmod dmfe mode=1 # Force 100M Half Duplex insmod dmfe mode=4 # Force 10M Full Duplex insmod dmfe mode=5 # Force 100M Full Duplex Next you should configure your network interface with a command similar to : ifconfig eth0 172.22.3.18 ^^^^^^^^^^^ Your IP Adress Then you may have to modify the default routing table with command : route add default eth0 Now your ethernet card should be up and running. TODO: Implement pci_driver::suspend() and pci_driver::resume() power management methods. Check on 64 bit boxes. Check and fix on big endian boxes. Test and make sure PCI latency is now correct for all cases. Authors: Sten Wang : Original Author Tobias Ringstrom : Current Maintainer Contributors: Marcelo Tosatti Alan Cox Jeff Garzik Vojtech Pavlik