From 8051effcbced8478119167b93b0e9554cb82d28e Mon Sep 17 00:00:00 2001 From: Magnus Damm Date: Thu, 26 Nov 2009 11:10:05 +0000 Subject: spi: SuperH MSIOF SPI Master driver V2 This patch is V2 of SPI Master support for the SuperH MSIOF. Full duplex, spi mode 0-3, active high cs, 3-wire and lsb first should all be supported, but the driver has so far only been tested with "mmc_spi". The MSIOF hardware comes with 32-bit FIFOs for receive and transmit, and this driver simply breaks the SPI messages into FIFO-sized chunks. The MSIOF hardware manages the pins for clock, receive and transmit (sck/miso/mosi), but the chip select pin is managed by software and must be configured as a regular GPIO pin by the board code. Performance wise there is still room for improvement, but on a Ecovec board with the built-in sh7724 MSIOF0 this driver gets Mini-sd read speeds of about half a megabyte per second. Future work include better clock setup and merging of 8-bit transfers into 32-bit words to reduce interrupt load and improve throughput. Signed-off-by: Magnus Damm Signed-off-by: Grant Likely --- drivers/spi/Makefile | 1 + 1 file changed, 1 insertion(+) (limited to 'drivers/spi/Makefile') diff --git a/drivers/spi/Makefile b/drivers/spi/Makefile index 2f2bebc63b6..9c51e252689 100644 --- a/drivers/spi/Makefile +++ b/drivers/spi/Makefile @@ -35,6 +35,7 @@ obj-$(CONFIG_SPI_XILINX) += xilinx_spi.o obj-$(CONFIG_SPI_XILINX_OF) += xilinx_spi_of.o obj-$(CONFIG_SPI_XILINX_PLTFM) += xilinx_spi_pltfm.o obj-$(CONFIG_SPI_SH_SCI) += spi_sh_sci.o +obj-$(CONFIG_SPI_SH_MSIOF) += spi_sh_msiof.o obj-$(CONFIG_SPI_STMP3XXX) += spi_stmp.o # ... add above this line ... -- cgit v1.2.3