From 4d2fafd17a325b3f4f5f9edb1211bc7f4c311269 Mon Sep 17 00:00:00 2001 From: Tear Date: Wed, 23 May 2007 14:12:30 -0700 Subject: ACPI: Remove Dell Optiplex GX240 from the ACPI blacklist I have a Dell Optiplex GX240 and when I boot Linux, ACPI gets set up by only acpi=ht. dmesg shows the following line: DELL GX240 detected: force use of acpi=ht Everything seemed to be fine. However, I discovered that everything is not fine. The USB controller works so slowly that copying a few (uncached) 1 megabyte large photos from a USB-enabled digital camera takes many minutes instead of a couple of seconds. I am using Linux 2.6.21.1 on a Debian 4.0 ("Etch") system. I thought that this might be related to ACPI. So I tried to boot with _only_ "acpi=force" appended to the kernel command line. Voila, the USB controller started to work at full speed and copying photos from my digital camera took only seconds. I tested the system with "acpi=force" and could not find anything which did not work. I thought that this might be related to interrupts and APIC as well. (Note that this is APIC, not ACPI.) I tried booting with _only_ "noapic" and "nolapic" appended to the command line. Again, the USB controller started to work at full speed. Signed-off-by: Andrew Morton Signed-off-by: Len Brown --- arch/i386/kernel/acpi/boot.c | 8 -------- 1 file changed, 8 deletions(-) (limited to 'arch') diff --git a/arch/i386/kernel/acpi/boot.c b/arch/i386/kernel/acpi/boot.c index 280898b045b..a2c8b9efd70 100644 --- a/arch/i386/kernel/acpi/boot.c +++ b/arch/i386/kernel/acpi/boot.c @@ -969,14 +969,6 @@ static struct dmi_system_id __initdata acpi_dmi_table[] = { DMI_MATCH(DMI_PRODUCT_NAME, "PRIMERGY T850"), }, }, - { - .callback = force_acpi_ht, - .ident = "DELL GX240", - .matches = { - DMI_MATCH(DMI_BOARD_VENDOR, "Dell Computer Corporation"), - DMI_MATCH(DMI_BOARD_NAME, "OptiPlex GX240"), - }, - }, { .callback = force_acpi_ht, .ident = "HP VISUALIZE NT Workstation", -- cgit v1.2.3