From fe21bb02ca3b312ba3b89382760e548fd8996a55 Mon Sep 17 00:00:00 2001 From: Jonas Gorski Date: Mon, 25 Mar 2013 16:39:54 +0100 Subject: mwl8k: always apply configuration even when device is idle Fix settings not being applied when the device is idle and the firmware gets reloaded (because of changing from STA to AP mode). This caused the device using the wrong channel (and likely band), e.g. a 5 GHz only card still defaulted to channel 6 in the 2.4 GHz band when left unconfigured. This issue was always present, but only made visible with "mwl8k: Do not call mwl8k_cmd_set_rf_channel unconditionally" (0f4316b9), since before that the channel was (re-)configured at the next _config call even when it did not change from the mac80211 perspective. Signed-off-by: Jonas Gorski Signed-off-by: John W. Linville --- drivers/net/wireless/mwl8k.c | 10 ++++------ 1 file changed, 4 insertions(+), 6 deletions(-) diff --git a/drivers/net/wireless/mwl8k.c b/drivers/net/wireless/mwl8k.c index 0640e7d7f0c..956c1084ebf 100644 --- a/drivers/net/wireless/mwl8k.c +++ b/drivers/net/wireless/mwl8k.c @@ -4807,16 +4807,14 @@ static int mwl8k_config(struct ieee80211_hw *hw, u32 changed) struct mwl8k_priv *priv = hw->priv; int rc; - if (conf->flags & IEEE80211_CONF_IDLE) { - mwl8k_cmd_radio_disable(hw); - return 0; - } - rc = mwl8k_fw_lock(hw); if (rc) return rc; - rc = mwl8k_cmd_radio_enable(hw); + if (conf->flags & IEEE80211_CONF_IDLE) + rc = mwl8k_cmd_radio_disable(hw); + else + rc = mwl8k_cmd_radio_enable(hw); if (rc) goto out; -- cgit v1.2.3