diff options
| -rw-r--r-- | drivers/ata/sata_mv.c | 42 |
1 files changed, 19 insertions, 23 deletions
diff --git a/drivers/ata/sata_mv.c b/drivers/ata/sata_mv.c index 5b9f937d0f8..16c15ed3536 100644 --- a/drivers/ata/sata_mv.c +++ b/drivers/ata/sata_mv.c @@ -2242,6 +2242,16 @@ static void mv_soc_reset_bus(struct ata_host *host, void __iomem *mmio) return; } +static void mv_setup_ifctl(void __iomem *port_mmio, int want_gen2i) +{ + u32 ifctl = readl(port_mmio + SATA_INTERFACE_CFG); + + ifctl = (ifctl & 0xf7f) | 0x9b1000; /* from chip spec */ + if (want_gen2i) + ifctl |= (1 << 7); /* enable gen2i speed */ + writelfl(ifctl, port_mmio + SATA_INTERFACE_CFG); +} + /* * Caller must ensure that EDMA is not active, * by first doing mv_stop_edma() where needed. @@ -2253,18 +2263,17 @@ static void mv_reset_channel(struct mv_host_priv *hpriv, void __iomem *mmio, writelfl(ATA_RST, port_mmio + EDMA_CMD_OFS); - if (IS_GEN_II(hpriv)) { - u32 ifctl = readl(port_mmio + SATA_INTERFACE_CFG); - ifctl |= (1 << 7); /* enable gen2i speed */ - ifctl = (ifctl & 0xfff) | 0x9b1000; /* from chip spec */ - writelfl(ifctl, port_mmio + SATA_INTERFACE_CFG); + if (!IS_GEN_I(hpriv)) { + /* Enable 3.0gb/s link speed */ + mv_setup_ifctl(port_mmio, 1); } - - udelay(25); /* allow reset propagation */ - - /* Spec never mentions clearing the bit. Marvell's driver does - * clear the bit, however. + /* + * Strobing ATA_RST here causes a hard reset of the SATA transport, + * link, and physical layers. It resets all SATA interface registers + * (except for SATA_INTERFACE_CFG), and issues a COMRESET to the dev. */ + writelfl(ATA_RST, port_mmio + EDMA_CMD_OFS); + udelay(25); /* allow reset propagation */ writelfl(0, port_mmio + EDMA_CMD_OFS); hpriv->ops->phy_errata(hpriv, mmio, port_no); @@ -2711,19 +2720,6 @@ static int mv_init_host(struct ata_host *host, unsigned int board_idx) hpriv->ops->enable_leds(hpriv, mmio); for (port = 0; port < host->n_ports; port++) { - if (IS_GEN_II(hpriv)) { - void __iomem *port_mmio = mv_port_base(mmio, port); - - u32 ifctl = readl(port_mmio + SATA_INTERFACE_CFG); - ifctl |= (1 << 7); /* enable gen2i speed */ - ifctl = (ifctl & 0xfff) | 0x9b1000; /* from chip spec */ - writelfl(ifctl, port_mmio + SATA_INTERFACE_CFG); - } - - hpriv->ops->phy_errata(hpriv, mmio, port); - } - - for (port = 0; port < host->n_ports; port++) { struct ata_port *ap = host->ports[port]; void __iomem *port_mmio = mv_port_base(mmio, port); |