iwlwifi: fix activating inactive stations

When authentication/association timed out, the driver would
complain bitterly, printing the message
ACTIVATE a non DRIVER active station id ... addr ...

The cause turns out to be that when the AP station is added
but we don't associate, the IWL_STA_UCODE_INPROGRESS is set
but never cleared. This then causes iwl_restore_stations()
to attempt to resend it because it uses the flag internally
and uploads even if it didn't set it itself.

To fix this issue and not upload the station again when it
has already been removed by mac80211, clear the flag after
adding it in case we add it only for association.

Cc: stable@vger.kernel.org
Reviewed-by: Meenakshi Venkataraman <meenakshi.venkataraman@intel.com>
Reviewed-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

1 files changed, 12 insertions, 0 deletions

diff --git a/drivers/net/wireless/iwlwifi/iwl-mac80211.c b/drivers/net/wireless/iwlwifi/iwl-mac80211.c
index 3ee23134c02..013680332f0 100644
--- a/drivers/net/wireless/iwlwifi/iwl-mac80211.c
+++ b/drivers/net/wireless/iwlwifi/iwl-mac80211.c
@@ -796,6 +796,18 @@ int iwlagn_mac_sta_state(struct ieee80211_hw *hw,
 	switch (op) {
 	case ADD:
 		ret = iwlagn_mac_sta_add(hw, vif, sta);
+		if (ret)
+			break;
+		/*
+		 * Clear the in-progress flag, the AP station entry was added
+		 * but we'll initialize LQ only when we've associated (which
+		 * would also clear the in-progress flag). This is necessary
+		 * in case we never initialize LQ because association fails.
+		 */
+		spin_lock_bh(&priv->sta_lock);
+		priv->stations[iwl_sta_id(sta)].used &=
+			~IWL_STA_UCODE_INPROGRESS;
+		spin_unlock_bh(&priv->sta_lock);
 		break;
 	case REMOVE:
 		ret = iwlagn_mac_sta_remove(hw, vif, sta);