[netdrvr] Use dev_printk() when ethernet interface isn't available

For messages prior to register_netdev(), prefer dev_printk() because
that prints out both our driver name and our [PCI | whatever] bus id.

Updates: 8139{cp,too}, b44, bnx2, cassini, {eepro,epic}100, fealnx,
	 hamachi, ne2k-pci, ns83820, pci-skeleton, r8169.

Signed-off-by: Jeff Garzik <jeff@garzik.org>

1 files changed, 19 insertions, 24 deletions

diff --git a/drivers/net/r8169.c b/drivers/net/r8169.c
index 16a0ef1b136..ae2a1f8f145 100644
--- a/drivers/net/r8169.c
+++ b/drivers/net/r8169.c
@@ -1406,7 +1406,8 @@ rtl8169_init_board(struct pci_dev *pdev, struct net_device **dev_out,
 	dev = alloc_etherdev(sizeof (*tp));
 	if (dev == NULL) {
 		if (netif_msg_drv(&debug))
-			printk(KERN_ERR PFX "unable to alloc new ethernet\n");
+			dev_printk(KERN_ERR, &pdev->dev,
+				"unable to alloc new ethernet\n");
 		goto err_out;
 	}
 
@@ -1418,10 +1419,8 @@ rtl8169_init_board(struct pci_dev *pdev, struct net_device **dev_out,
 	/* enable device (incl. PCI PM wakeup and hotplug setup) */
 	rc = pci_enable_device(pdev);
 	if (rc < 0) {
-		if (netif_msg_probe(tp)) {
-			printk(KERN_ERR PFX "%s: enable failure\n",
-			       pci_name(pdev));
-		}
+		if (netif_msg_probe(tp))
+			dev_printk(KERN_ERR, &pdev->dev, "enable failure\n");
 		goto err_out_free_dev;
 	}
 
@@ -1437,37 +1436,33 @@ rtl8169_init_board(struct pci_dev *pdev, struct net_device **dev_out,
 		pci_read_config_word(pdev, pm_cap + PCI_PM_CTRL, &pwr_command);
 		acpi_idle_state = pwr_command & PCI_PM_CTRL_STATE_MASK;
 	} else {
-		if (netif_msg_probe(tp)) {
-			printk(KERN_ERR PFX
+		if (netif_msg_probe(tp))
+			dev_printk(KERN_ERR, &pdev->dev,
 			       "PowerManagement capability not found.\n");
-		}
 	}
 
 	/* make sure PCI base addr 1 is MMIO */
 	if (!(pci_resource_flags(pdev, 1) & IORESOURCE_MEM)) {
-		if (netif_msg_probe(tp)) {
-			printk(KERN_ERR PFX
+		if (netif_msg_probe(tp))
+			dev_printk(KERN_ERR, &pdev->dev,
 			       "region #1 not an MMIO resource, aborting\n");
-		}
 		rc = -ENODEV;
 		goto err_out_mwi;
 	}
 	/* check for weird/broken PCI region reporting */
 	if (pci_resource_len(pdev, 1) < R8169_REGS_SIZE) {
-		if (netif_msg_probe(tp)) {
-			printk(KERN_ERR PFX
+		if (netif_msg_probe(tp))
+			dev_printk(KERN_ERR, &pdev->dev,
 			       "Invalid PCI region size(s), aborting\n");
-		}
 		rc = -ENODEV;
 		goto err_out_mwi;
 	}
 
 	rc = pci_request_regions(pdev, MODULENAME);
 	if (rc < 0) {
-		if (netif_msg_probe(tp)) {
-			printk(KERN_ERR PFX "%s: could not request regions.\n",
-			       pci_name(pdev));
-		}
+		if (netif_msg_probe(tp))
+			dev_printk(KERN_ERR, &pdev->dev,
+				"could not request regions.\n");
 		goto err_out_mwi;
 	}
 
@@ -1480,10 +1475,9 @@ rtl8169_init_board(struct pci_dev *pdev, struct net_device **dev_out,
 	} else {
 		rc = pci_set_dma_mask(pdev, DMA_32BIT_MASK);
 		if (rc < 0) {
-			if (netif_msg_probe(tp)) {
-				printk(KERN_ERR PFX
+			if (netif_msg_probe(tp))
+				dev_printk(KERN_ERR, &pdev->dev,
 				       "DMA configuration failed.\n");
-			}
 			goto err_out_free_res;
 		}
 	}
@@ -1494,7 +1488,8 @@ rtl8169_init_board(struct pci_dev *pdev, struct net_device **dev_out,
 	ioaddr = ioremap(pci_resource_start(pdev, 1), R8169_REGS_SIZE);
 	if (ioaddr == NULL) {
 		if (netif_msg_probe(tp))
-			printk(KERN_ERR PFX "cannot remap MMIO, aborting\n");
+			dev_printk(KERN_ERR, &pdev->dev,
+				"cannot remap MMIO, aborting\n");
 		rc = -EIO;
 		goto err_out_free_res;
 	}
@@ -1526,9 +1521,9 @@ rtl8169_init_board(struct pci_dev *pdev, struct net_device **dev_out,
 	if (i < 0) {
 		/* Unknown chip: assume array element #0, original RTL-8169 */
 		if (netif_msg_probe(tp)) {
-			printk(KERN_DEBUG PFX "PCI device %s: "
+			dev_printk(KERN_DEBUG, &pdev->dev,
 			       "unknown chip version, assuming %s\n",
-			       pci_name(pdev), rtl_chip_info[0].name);
+			       rtl_chip_info[0].name);
 		}
 		i++;
 	}